User`s manual

SIP User's Manual 164 Document #: LTRT-83303
Mediant 1000 & Mediant 600
Parameter Description
Dial Tone Duration [sec]
[TimeForDialTone]
Duration (in seconds) that the dial tone is played (for digital interface: to an
ISDN terminal).
For digital interfaces: This parameter is applicable for overlap dialing when
ISDNInCallsBehavior = 65536. The dial tone is played if the ISDN SETUP
message doesn't include the called number.
The valid range is 0 to 60. The default is 5.
For Mediant 1000 analog interfaces: FXS interface plays the dial tone after
the phone is picked up (off-hook); while FXO interface plays the dial tone
after port is seized in response to ringing (from PBX/PSTN). The default
time is 16.
Notes for Mediant 1000 analog interfaces:
 During play of dial tone, the device waits for DTMF digits.
 This parameter is not applicable when Automatic Dialing is enabled.
Hotline Dial Tone
Duration
[HotLineToneDuration]
Duration (in seconds) of the Hotline dial tone. If no digits are received
during this duration, the device initiates a call to a user-defined number
(refer to Automatic Dialing on page 220).
The valid range is 0 to 60. The default is 16.
Note: This parameter is applicable only to Mediant 1000 for both FXS and
FXO interfaces.
Enable Special Digits
[IsSpecialDigits]
Determines whether the asterisk (*) and pound (#) digits can be used.
 [0] Disable = Use '*' or '#' to terminate number collection (refer to the
parameter UseDigitForSpecialDTMF). (Default.)
 [1] Enable = Allows '*' and '#' for telephone numbers dialed by a user or
for the endpoint telephone number.
Notes:
 This parameter is applicable only to Mediant 1000.
 These symbols can always be used as the first digit of a dialed number,
even if you disable this parameter.
Default Destination
Number
[DefaultNumber]
Defines the default destination phone number used if the received
message doesn't contain a called party number and no phone number is
configured in the 'Trunk Group' table (refer to "Configuring the Trunk Group
Table" on page 226). The parameter is used as a starting number for the
list of channels comprising all trunk groups in the device.
The default value is 1000.
Special Digit
Representation
[UseDigitForSpecialDT
MF]
Defines the representation for ‘special’ digits (‘*’ and ‘#’) that are used for
out-of-band DTMF signaling (using SIP INFO/NOTIFY).
 [0] Special = Uses the strings ‘*’ and ‘#’ (default).
 [1] Numeric = Uses the numerical values 10 and 11.