User`s manual

SIP User's Manual 154 Document #: LTRT-83303
Mediant 1000 & Mediant 600
¾ To add Proxy servers and configure Proxy parameters, take these
5 steps:
1. Open the 'Proxy Sets Table' page (Configuration tab > Protocol Configuration
menu > Protocol Definition submenu > Proxy Sets Table page item).
Figure 3-66: Proxy Sets Table Page
2. From the Proxy Set ID drop-down list, select an ID for the desired group.
3. Configure the Proxy parameters according to the following table.
4. Click the Submit button to save your changes.
5. To save the changes to flash memory, refer to ''Saving Configuration'' on page 265.
Table 3-33: Proxy Sets Table Parameters
Parameter Description
Proxy Set ID
The Proxy Set identification number.
The valid range is 0 to 5 (i.e., up to 6 Proxy Set ID's can be configured). The
Proxy Set ID #0 is used as the default Proxy Set, and if defined is backward
compatible to the list of Proxies from earlier releases.
You can define up to five IP addresses per Proxy Set. And per each IP
address to define UDP, TCP or TLS transport type.
Note: Although not recommended, you can use both default Proxy Set (ID
#0) and IP Groups for call routing. For example, on the 'Trunk Group
Settings' page (refer to ''Configuring the Trunk Group Settings'' on page
228), you can configure a Serving IP Group to where you want to route
specific Trunk Group's channels, while all other device channels uses the
default Proxy Set. At the same, you can also use IP Groups in the 'Tel to IP
Routing' table (refer to ''Tel to IP Routing Table'' on page 200) to configure
the default Proxy Set if the parameter PreferRouteTable is set to 1.