User`s manual

SIP User's Manual 152 Document #: LTRT-83303
Mediant 1000 & Mediant 600
Parameter Description
User Name
[UserName]
User name used for Registration and Basic/Digest authentication with a
Proxy / Registrar server.
The parameter doesn't have a default value (empty string).
Notes:
 Applicable only if single device registration is used (i.e., Authentication
Mode is set to Authentication Per gateway).
 For Mediant 1000: The Authentication table can be used instead (refer to
Authentication on page 219).
Password
[Password]
The password used for Basic/Digest authentication with a Proxy / Registrar
server. A single password is used for all device ports.
The default is 'Default_Passwd'.
Note: For Mediant 1000: The Authentication table can be used instead (refer
to Authentication on page 219).
Cnonce
[Cnonce]
Cnonce string used by the SIP server and client to provide mutual
authentication. (Free format, i.e., 'Cnonce = 0a4f113b'). The default is
'Default_Cnonce'.
Authentication Mode
[AuthenticationMode]
Determines the device's registration and authentication method.
 [0] Per Endpoint = Registration and Authentication separately for each
endpoint/B-channel.
 [1] Per Gateway = Single Registration and Authentication for the entire
device (default).
 [3] Per FXS = Registration and Authentication for Mediant 1000 FXS
endpoints.
Typically, Authentication per endpoint is used for Mediant 1000 FXS
interfaces,where each endpoint registers (and authenticates) separately with
its own user name and password.
Single Registration and Authentication (Authentication Mode = 1) is usually
defined for FXO (for Mediant 1000) and digital modules.
Set Out-Of-Service On
Registration Failure
[OOSOnRegistrationF
ail]
Enables setting an endpoint or the entire device (i.e., all endpoints) to out-of-
service if registration fails.
 [0] Disable = Disabled (default).
 [1] Enable = Enabled.
If the registration is per endpoint (i.e., AuthenticationMode is set to 0) and a
specific endpoint registration fails (4xx or no response), then that endpoint is
set to out-of-service until a success response is received in a subsequent
registration request. When the registration is per the entire device (i.e.,
AuthenticationMode is set to 1) and registration fails, all endpoints are set to
out-of-service.
The out-of-service method is set according to the parameter
FXSOOSBehavior.
Note: This parameter is applicable only to Mediant 1000.