User`s manual

SIP User's Manual 148 Document #: LTRT-83303
Mediant 1000 & Mediant 600
Parameter Description
Prefer Routing Table
[PreferRouteTable]
Determines if the 'Tel to IP Routing' table takes precedence over a Proxy for
routing calls.
 [0] No = Only Proxy is used to route calls (default).
 [1] Yes = The device checks the 'Dest Phone Prefix' and/or 'Source
Phone Prefix' fields in the 'Tel to IP Routing' table for a match with the
Tel-to-IP call. Only if a match is not found, a Proxy is used.
Note: Applicable only if Proxy is not always used (AlwaysSendToProxy = 0,
SendInviteToProxy = 0).
Use Routing Table for
Host Names and
Profiles
[AlwaysUseRouteTabl
e]
Use the internal 'Tel to IP Routing' table to obtain the URI Host name and
(optionally) an IP profile (per call), even if a Proxy server is used.
 [0] Disable = Don't use (default).
 [1] Enable = Use the internal 'Tel to IP Routing' table.
Note: This domain name is used instead of a Proxy name or IP address in
the INVITE SIP URI.
Always Use Proxy
[AlwaysSendToProxy
]
Determines whether the device sends SIP messages and responses through
a Proxy server.
 [0] Disable = Use standard SIP routing rules (default).
 [1] Enable = All SIP messages and responses are sent to a Proxy server.
Note: Applicable only if Proxy server is used (i.e., the parameter
IsProxyUsed is set to 1).
Send All INVITE to
Proxy
[SendInviteToProxy]
Determines whether INVITE messages, as a result of Transfer or Redirect
are sent to a Proxy server instead of directly to the URI.
 [0] No = (default) INVITE messages from Transfer or Redirect are sent
directly to the URI (according to the Refer-To header in the REFER
message or Contact header in 30x response).
 [1] Yes = All INVITE messages, including those generated as a result of
Transfer or Redirect are sent to a Proxy server.
Note: Applicable only if a Proxy server is used and the parameter
AlwaysSendtoProxy is set to 0.
Proxy / Registrar Registration parameters
(Note: The proxy and registrar parameter fields appear only if 'Enable Registration' is enabled.)
Enable Registration
[IsRegisterNeeded]
Enables the device to register to a Proxy / Registrar server.
 [0] Disable = device doesn't register to Proxy / Registrar (default) server.
 [1] Enable = device registers to Proxy / Registrar server when the device
is powered up and at every user-defined interval (configured by the
parameter RegistrationTime).
Note: The device sends a REGISTER request for each channel or for the
entire device (according to the AuthenticationMode parameter).
Registrar Name
[RegistrarName]
Registrar domain name. If specified, the name is used as the Request-URI in
REGISTER messages. If it isn't specified (default), the Registrar IP address,
or Proxy name or IP address is used instead.
The valid range is up to 49 characters.