User`s manual

SIP User's Manual 130 Document #: LTRT-83303
Mediant 1000 & Mediant 600
3.4.4.7 Configuring the IKE Table
The 'IKE Table' page is used to configure the Internet Key Exchange (IKE) parameters.
Note: You can also configure the IKE table using the ini file table parameter
IPSec_IKEDB_Table (refer to ''Security Parameters'' on page 314).
¾ To configure the IKE table, take these 5 steps:
1. Open the ‘IKE Table’ page (Configuration tab > Security Settings menu > IKE
Table page item).
Figure 3-64: IKE Table Page
2. From the ‘Policy Index’ drop-down list, select the peer you want to edit (up to 20 peers
can be configured).
3. Configure the IKE parameters according to the table below. Up to two IKE main mode
proposals (Encryption / Authentication / DH group combinations) can be defined. The
same proposals must be configured for all peers.
4. Click Create; a row is created in the IKE table.
5. To save the changes to flash memory, refer to ''Saving Configuration'' on page 265.
To delete a peer from the IKE table, select it from the ‘Policy Index’ drop-down list, click the
button Delete, and then click OK at the prompt.