User`s manual

Version 5.4 127 May 2008
SIP User's Manual 3. Web-Based Management
¾ To configure the IPSec SPD table, take these 5 steps:
1. Open the ‘IPSec Table’ page (Configuration tab > Security Settings menu > IPSec
Table page item).
Figure 3-63: IPSec Table Page
2. From the ‘Policy Index’ drop-down list, select the rule you want to edit (up to 20 policy
rules can be configured).
3. Configure the IPSec SPD parameters according to the table below.
4. Click the button Create; the IPSec rule is applied on-the-fly to the device.
5. To save the changes to flash memory, refer to ''Saving Configuration'' on page 265.
If no IPSec methods are defined (Encryption / Authentication), the default settings, shown
in the following table are applied.
Table 3-27: Default IKE Second Phase Proposals
Proposal Encryption Authentication
Proposal 0
3DES SHA1
Proposal 1
3DES MD5
Proposal 2
DES SHA1
Proposal 3
DES MD5