User`s manual

SIP User's Manual 112 Document #: LTRT-83303
Mediant 1000 & Mediant 600
 Certificates (refer to ''Configuring the Certificates'' on page 118)
 General Security Settings (refer to ''Configuring the General Security Settings'' on
page 123)
 IPSec Table (refer to ''Configuring the IPSec Table'' on page 126)
 IKE Table (refer to ''Configuring the IKE Table'' on page 130)
3.4.4.1 Configuring the Web User Accounts
To prevent unauthorized access to the Web interface, two Web user accounts are available
(primary and secondary) with assigned user name and password. When you login to the
Web interface, you are requested to provide this user name and password. If the Web
session is idle (i.e., no actions are performed) for more than five minutes, the Web session
expires and you are once again requested to login with your user name and password. Up
to five Web users can simultaneously open (log in to) a session on the device's Web
interface.
Each Web user account is composed of three attributes:
 User name and password: enables access (login) to the Web interface.
 Access level: determines the extent of the access (i.e., availability of pages and read
/ write privileges).
You can change the user name, password, and access level of each Web user account.
The available access levels and their corresponding privileges are listed in the table below:
Table 3-23: Web User Accounts Access Levels and Privileges
Access Level
Numeric
Representation*
Privileges
Security Administrator
200 Read / write privileges for all pages.
Administrator
100
read / write privileges for all pages except
security-related pages, which are read-only.
User Monitor
50
No access to security-related and file-loading
pages; read-only access to the other pages.
No Access
0 No access to any page.
* The numeric representation of the access level is used only to define accounts in a RADIUS server
(the access level ranges from 1 to 255).
Read-only access level (i.e., 'User Monitor') is typically applied to the secondary Web user
account. The distribution of the primary and secondary Web user accounts to users is
according to your organization's security policy.
The default attributes for the two Web user accounts are shown in the following table:
Table 3-24: Default Attributes for the Web User Accounts
Account / Attribute User Name
(Case-Sensitive)
Password
(Case-Sensitive)
Access Level
Primary Account
Admin Admin Security Administrator
Secondary Account
User User User Monitor