User`s manual

Version 5.4 111 May 2008
SIP User's Manual 3. Web-Based Management
Table 3-22: CAS State Machine Parameters Description
Parameter Description
Generate Digit On Time
[CasStateMachineGenerateD
igitOnTime]
Generates digit on-time (in msec).
The value must be a positive value. The default value is -1.
Generate Inter Digit Time
[CasStateMachineGenerateIn
terDigitTime]
Generates digit off-time (in msec).
The value must be a positive value. The default value is -1.
DTMF Max Detection Time
[CasStateMachineDTMFMax
OnDetectionTime]
Detects digit maximum on time (according to DSP detection
information event) in msec units.
The value must be a positive value. The default value is -1.
DTMF Min Detection Time
[CasStateMachineDTMFMinO
nDetectionTime]
Detects digit minimum on time (according to DSP detection
information event) in msec units. The digit time length must be longer
than this value to receive a detection. Any number may be used, but
the value must be less then
CasStateMachineDTMFMaxOnDetectionTime.
The value must be a positive value. The default value is -1.
MAX Incoming Address Digits
[CasStateMachineMaxNumO
f
IncomingAddressDigits]
Defines the limitation for the maximum address digits that need to be
collected. After reaching this number of digits, the collection of
address digits is stopped.
The value must be an integer. The default value is -1.
MAX Incoming ANI Digits
[CasStateMachineMaxNumO
f
IncomingANIDigits]
Defines the limitation for the maximum ANI digits that need to be
collected. After reaching this number of digits, the collection of ANI
digits is stopped.
The value must be an integer. The default value is -1.
Collet ANI
[CasStateMachineCollectANI
]
In some cases, when the state machine handles the ANI collection
(not related to MFCR2), you can control the state machine to collect
ANI or discard ANI.
 [0] No = Don't collect ANI.
 [1] Yes = Collect ANI.
 [-1] Default = Default value.
Digit Signaling System
[CasStateMachineDigitSignal
ingSystem]
Defines which Signaling System to use in both directions
(detection\generation).
 [0] DTMF = Uses DTMF signaling.
 [1] MF = Uses MF signaling (default).
 [-1] Default = Default value.
3.4.4 Security Settings
The Security Settings menu allows you to configure various security settings. This menu
contains the following page items:
 Web User Accounts (refer to ''Configuring the Web User Accounts'' on page 112)
 Web & Telnet Access List (refer to ''Configuring the Web and Telnet Access List'' on
page 114)
 Firewall Settings (refer to ''Configuring the Firewall Settings'' on page 115)