Installation manual

Version 6.0 13 February 2010
Installation Manual 2. Installing the Device
Item # Label Component Description
Enlarged View of CPU (#3)
4
I
Dry contact port (normally open) - can be connected to an external audible or
visual alarm system (bell, siren, hooter, or light).
5
II
Dry contact port (normally closed) - can be connected to an external audible
or visual alarm system (bell, siren, hooter, or light).
6
♫
Audio IN/OUT. (Currently, not applicable.)
7
I
10/100Base-TX Ethernet Port 1. (Two Ethernet ports provide a dual Ethernet
redundancy scheme, protecting against failure such as a disconnection of any
cable or associated LAN switch port.)
8
II
10/100Base-TX Ethernet Port 2. Refer to description above.
9
I0I0
RS-232 port - for accessing the CLI and for receiving error / notification
messages. A 9-pin DB adapting cable is supplied.
10
//
Reset button - for resetting the device and optionally, for restoring the device's
parameters to their factory defaults (refer to ‘Restoring Factory Default
Settings’ on page 43).
2.1.2 Rear Panel
The device's rear panel is shown in the figure below and described in the subsequent table.
Figure 2-2: Mediant 600 Rear Panel
Table 2-2: Mediant 600 Rear Panel Components Description
Item # Label Component Description
1
100 - 240V
0.5A
50-60Hz
AC power supply entry plug.
2
ESD
Electrostatic Discharge (ESD) socket - for attaching an anti-static wrist
strap to your wrist and to the ESD socket on the chassis.
3
Protective earthing screw.