Product specifications

Administrator's Manual 3. Creating a Configuration File for Auto Provisioning via DHCP
Version 2.0.1 27 May 2013
 Using the configuration file:
Table 3-6: Dial Tones Parameters
Parameter
Description
Dial Tone Timeout
[voip/dialing/dialtone_timeout]
Defines the maximum duration of the dial tone (in
seconds) after which the dial tone stops and a
reorder tone is played.
The valid range is 1 to 300. The default value is
30.
Reorder Tone Timeout
[voip/dialing/warning_tone_timeout]
Defines the maximum duration of the reorder
tone (in seconds) after which the reorder tone
stops and a howler tone is played.
The valid range is 1 to 300. The default value is
40.
Howler Tone Timeout
[voip/dialing/offhook_tone_timeout]
Defines the duration (in seconds) of the howler
tone. If the limit is exceeded, the howler tone
stops. The howler tone indicates that the phone
has been left in an off-hook state.
The valid range is 1 to 300. The default value is
120.
Secondary Dial Tone
[voip/dialing/secondary_dial_tone/enabled]
Enables the secondary dial tone.
 [0] Disable - Phone doesn't use secondary
dial tone.
 [1] Enable (default) - Phone plays secondary
dial tone if the secondary dial tone key is
pressed (first digit).
Secondary Dial Tone Key
[voip/dialing/secondary_dial_tone/key_seq
uence]
Defines the secondary dial tone is played if this is
the first key pressed.
The valid range is 0 to 9. The default value is 9.
Note: This parameter is available only if the
parameter
voip/dialing/secondary_dial_tone/enabled is
set to 1.
Out of Service Behavior
[voip/services/out_of_service_behavior]
Determines whether a reorder tone is played
instead of a dial tone if you configured a
Registrar IP address and the registration failed.
 [NONE] No Tone
 [REORDER_TONE] Reorder Tone (default)
Stutter Tone Duration
[voip/services/msg_waiting/stutter_tone_d
uration]
Defines the duration for which a stutter tone is
played when you have unheard messages.
The valid range is 1000 to 60000.
The default value is 2500.
Automatic Disconnect
[voip/dialing/automatic_disconnect]
Determines whether the phone automatically
goes idle (i.e. on-hook) when the last remaining
call is disconnected. This is only relevant when
the speaker or headset is used.
 [0] Disable
 [1] Enable(default)