User`s manual

User's Manual 2. Hardware Setup
Version 1.4 15 July 2010
2.3 Cabling the Phone
The procedure below describes how to cable your phone.
¾ To cable the phone:
1. Connect the RJ-9 handset jack to the handset.
2. (Optional) Connect the RJ-9 headset jack to a headset.
3. Connect the LAN port to the IP network, using a CAT 5 Ethernet cable.
4. Connect the PC port to your computer, using a CAT 5, straight-through Ethernet cable.
5. Connect the connector tip of the AC power adapter to the phone’s power socket (labeled DC
12V). Connect the two-prong AC adapter directly to the electrical wall outlet. The phone’s
LEDs light red to indicate that the phone is connected to power.
Note: If the LAN to which the phone is connected supports Power over Ethernet (PoE),
no AC adapter is needed; the phone draws power from the Ethernet network.
Figure 2-3: Cabling the IP Phone