Specifications

310HD, 320HD and 420HD IP Phones
21.2 Configuring Lines using Web and Configuration File
Before you can make a call on your phone, you must configure a phone line. Lines can be
configured using the Web or Configuration File, as described below.
 To configure lines:
 Using the Web:
1. Access the ‘Line Settings’ page (Configuration tab > Voice Over IP menu >
Line Settings).
Figure 21-1: Voice Web Fields
2. Configure the Line settings according to the parameters in the table below, and
then click Submit.
 Using the Configuration File:
Table 21-11: Line Parameters
Parameter Description
Note: The value %d refers to the line number.
Line Activate
[voip/line/%d/enabled]
Enables the line.
 [0] Disable
 [1] Enable
The default for Line-0 is 1 (enabled); for the other lines it is
0 (disabled).
Line User ID
[voip/line/%d/id]
Lines VoIP user’s ID for identification to initiate and accept
calls.
The user’s ID can be up to 30 characters.
Line Display Name
[voip/line/%d/description]
Arbitrary name to intuitively identify the line and that is
displayed to remote parties as your caller ID.
Line Authentication User Name
voip/line/%d/auth_name
User name provided to you from the VoIP service provider.
This is used when sending a response to Unauthorized or
Proxy Authentication Requested (401/407).
The authentication name can be up to 35 characters.
Line Authentication Password
voip/line/%d/auth_password
Password provided to you from the VoIP Service Provider.
This is used when sending a response to Unauthorized or
Proxy Authentication Requested (401/407).
The authentication password can be up to 35 characters.
Administrator's Manual 132 Document #: LTRT-09910