Specifications

Administrator's Manual 18. Dialing Settings
Parameter Description
 9011xxx.: International rule with prefix
 1[2-9]xxxxxxxxx: LD rule without prefix
 91[2-9]xxxxxxxxx: LD rule with prefix
 9[2-9]xxxxxx: Local call with prefix
 *xx: 2-digit star codes
 [1-7]xx: A regular 3 digit extension that does not
start with 9 or 8 is dialed immediately
 [2-7]xx: A regular 3 digit extension that does not
start with 9 or 8 or 1 is dialed immediately
 [2-7]xxx: A regular 4 digit extension that does not
start with 9 or 8 or 1 is dialed immediately
 [8]xxx: A 3 digit extension prefixed with an 8 (routes
calls directly to voicemail of extension xxx)
 [8]xxxx: A 4 digit extension prefixed with an 8
(routes calls directly to voicemail of extension xxxx)
 T: Refers to the Dialing Timeout.
 Using ‘;’ separator: An ‘x’ in the pattern indicates any
digit. ‘;’ separates between patterns.
For example: '10x;05xxxxxxxx;4xxx'.
In this example, three patterns are defined. A number
that starts with 10 is terminated after the third digit, and
so on. If the user dials a number that does not match any
pattern, the number is terminated using the timeout or
when the user presses the pound (‘#’) key.
voip/signalling/sip/number_rules
This parameter works in conjunction with the parameter
voip/signalling/sip/digit_map and enables translation of
specific patterns to specific SIP destination addresses. An ‘x’
represents any dialed digit. Each backslash at the right side
of the ‘=’ represents one of the dialed digits. Rules are
separated by the character ';'.
The valid value can be up to 256 characters.
For example: '4xxx=Line_\\\@10.1.2.3'
This rule issues a call to 10.1.2.3 with the SIP ID of Line_
followed by the last three digits of the dialed number.
Version 2.0.0 115 October 2012