Specifications
310HD IP Phone
Administrator's Manual 50 Document #: 299-13801
Parameter Description
Reorder Tone Timeout
The duration (in seconds) of the Reorder tone. The Reorder tone is played for
example, when the phone receives a SIP “486” response. If the limit is
exceeded, the Reorder tone stops and a Howler tone is played to the user
No Answer Call Timeout
Timeout before the phone automatically sends a Cancel message. When the
phone makes a call and the other side doesn’t answer, the phone sends a
Cancel after this timeout.
Howler Tone Timeout
The duration (in seconds) of the Howler tone. If the limit is exceeded, the
Howler tone stops. The Howler tone indicates that the phone has been left in
an off-hook state.
DTMF Transport Mode
DTMFs are the tones generated by your telephone's keypad.
Inband
RFC 2833
Via SIP
Digit Map
Enables the ISP to predefine possible formats (or patterns) for the dialed
number. A match to one of the defined patterns terminates the dialed number.
An ‘x’ in the pattern indicates any digit. ‘;’ separates between patterns.
Example: '10x;05xxxxxxxx;4xxx'.
In this example, three patterns are defined. A number that starts with 10 is
terminated after the third digit, and so on. If the user dials a number that does
not match any pattern, the number is terminated using the timeout or when
the user presses the pound (‘#’) key.
Dial Plan
This parameter works in conjunction with the Digit Map and enables
translation of specific patterns to specific SIP destination addresses. An ‘x’
represents any dialed digit. Each backslash at the right side of the ‘=’
represents one of the dialed digits.
Example: '4xxx=Line_\\\@10.1.2.3'
This rule issues a call to 10.1.2.3 with the SIP ID of Line_ followed by the last
three digits of the dialed number.
Rules are separated by the character ';.'
Automatic Dialing
Activate
Enables automatic dialing when the user picks up (i.e., off-hooks) the phone.
Enable
Disable (default)
Timeout
Timeout (in seconds) before automatic dialing occurs. When set to 0,
automatic dialing is performed immediately.
Note: This parameter appears only when Automatic Dialing is enabled.
Destination Phone
Number
The automatic dialing destination.
Note: This parameter appears only when Automatic Dialing is enabled.