QUALITY, RELIABILITY, & PURE BLISS 25MM TITANIUM DOME TWEETER AT70V OPERATING INTSTRUCTIONS PLEASE RETAIN MANUAL FOR FUTURE USE AND REFERENCE
The Audiobahn Way To bring the product to market that excites the consumer through sound and vision from an orientation of integrity and customer service. We make you look as good as you sound. We strive to take car audio to an extreme the world has never seen, and a world that never stops evolving.
Table of Contents INTRODUCTION 3 SPECIFICATIONS AND WIRING 4 INSTALLATION 5-6 TROUBLESHOOTING 8 WARNING / DISCLAIMER 9 WARRANTY 9-10 2
Introduction Dear Customer, Congratulations on your purchase of the worlds finest brand of car audio products. Here at Audiobahn Inc. we are devoted to making our musical reproduction the vert best, and we are pleased you have chosen our product. Through years of engineering expertise, hand craftsmanship, and critical testing procedures, we have created a wide range of products that reproduce music with all the clarity and richness you deserve.
Specifications and Wiring AT70 POLISHED ALUMINUM CASE FERRO FLUID COOLED, HIGH-FLUX NEODYMIUM MAGNET FLUSH AND ANGLED SURFACE MOUNT HARDWARE 12dB CROSSOVER WITH AUDIOPHILE GRADE CAPACITORS AND POLYSWITCH PROTECTION 4 OHM IMPEDANCE FREQUENCY RESPONSE: 2kHz - 22kHz POWER HANDLING 120 WATTS RMS PER PAIR / 240 WATTS ACH POWER SENSITIVITY 90dB 1W / 1M Wiring Audiobahn recommends using at least 18-gauge wire with your new speaker system.
Installation INPUT IN- TW- IN+ TW+ Tweeter Crossover When wiring the tweeter to the crossover the wire with the red line is + (Positive) and the plain wire is - (Negative). This is the same with the connection to the amplifier or other source for power. Mounting Crossover screw bottomcap screw crossover topcap The crossover will allow the tweeter to play the correct frequencies without sending harmful low frequencies to the tweeter.
Installation screw cap Tweeter First Mounting 1. First find a location that you would like to mount the tweeter 2. Draw a small dot on the location of each tweeter and make sure that both tweeters are mounted equally 3. Remove pannel and double check that there is enough room behind the pannel for the tweeter (At least 1" depth and 2" diameter) 4. Drill a hole for the supplied flush mount cup 5. Insert the tweeter and make sure that it fits in to the hole that you just have drilled 6.
Troubleshooting In the event that your Audiobahn speakers appear to require service we ask that you first do a little trouble shooting to determine if the problem is actually the speaker, or a problem located in a different part of the vehicle such as the amplifier, wiring, fusing or possibly the source unit.
����������������������������������������������������� Warning / Disclaimer WARNING Investigate the layout of your automobile thoroughly before drilling or cutting any holes. Take care when you work near gas tanks, gas lines, hydraulic lines, and electrical wiring. Do not use the power amplifier unmounted. Attach the system securely to the automobile to prevent damage, particularly in the event of an accident.
