QUALITY, RLIABILITY, & PURE BLISS AS SERIES DUAL CONE FULL-RANGE SPEAKERS AS13N / AS14N / AS24N / AS15N / AS16N OPERATING INTSTRUCTIONS PLEASE RETAIN MANUAL FOR FUTRE USE AND REFERENCE
Table of Contents Getting Started----------------------------------------------------- 2 Introduction---------------------------------------------------------- 3 Features and Specifications------------------------------------- 4 Wiring----------------------------------------------------------------- 5 Choosing a Location----------------------------------------------- 6 Installation------------------------------------------------------------ 7 Wiring----------------------------------------------------------
Features and Specifications Features Chrome Basket Black Carbon Injection Cone Butyl Rubber Surround 2 Layer High-Temp ASV Voice Coil 4 Ohm Impedance Mylar Whizzer Tweeter Complete with Mounting Hardware Specifications Power Handling AS13N: AS14N: AS24N: AS15N: AS16N: 40 Watts RMS 60 Watts RMS 60 Watts RMS 60 Watts RMS 60 Watts RMS Magnet Weight AS13N: AS14N: AS24N: AS15N: AS16N: 3 oz. 4 oz. 4 oz. 4 oz. 10 oz.
Wiring The picture below is a representation of the connection terminals on all the AS Series Dual Cone Speakers. The picture is shown as if you are looking at the speaker with the cone facing up towards the sky. You will notice a large terminal on the left and a smaller terminal on the right. The large terminal is the positive (+) connection and the smaller terminal is the negative (-) connection.
Choosing A Location It is always best to plan the complete installation prior to attempting to install any product. The routing of wires, power connections and mounting locations should be planned first. As with any car stereo installation, and all work performed should be checked thoroughly and carefully prior to the operation of the system. The placement of your Audiobahn speakers within your vehicle will greatly affect the overall performance of your audio system.
Installation Installation Note: Audiobahn strongly recommends that you operate your system at low volumes prior to the completed installation of your Audiobahn speakers. This will allow a test of the speaker before securing it to its permanent location. Caution: Make sure that all speaker wiring is fully protected from cuts, tears and possible wear. All short circuits developing as a result could severely damage the source unit or possibly the amplifier as well as the speakers themselves.
Wiring Wiring Audiobahn recommends using at least 18-gauge wire with your new speaker system. Thinner gauge wire may easily be severed and can cause damage to your system should any bare wires come in contact with the vehicles chassis. Makes sure that your audio system is off while installing and connecting your new Audiobahn speakers. Failure to do so could result in damaging the speaker beyond repair. This is not something that would be covered under the manufacturer warranty.
Securing the Speaker Securing the Speaker Once you have tested your system and confirmed that it is operating properly, turn off your system and prepare for the final mounting of the speakers. 1) Position the speaker into the mounting hole and confirm the correct mounting location and hole placement. Screw clips are provided to insure a snug fit. Place crew clips over the metal surface and line up the hole with the hole you have previously drilled. Place the speaker into the hole.
10
11
12
13
