Specifications
INSTALLATION
NOTE: Audiobahn strongly recommends that you operate your system at low
volumes prior to the completed installation of your Audiobahn speakers. This will
allow a test of the speaker before securing it to its permanent location.
CAUTION: Make sure that all speaker wiring is fully protected from cuts, tears and
poss
ible wear. All short circuits developing as a result could severely damage the
source unit or possibly the amplifier. Make sure all speaker wires easily reach the
speaker terminal with no stress on the wire or connectors.
**MOUNTING
1. Confirm the mounting location and depth requirements by inspecting the area
where the spea
ker will be mounted. Most speakers will fit into stock locations on the
vehicle, in this case only depth is important.
2. If the location you have picked dose require cutting, you may use the supplied
template to help you locate and make the mounting location and cuts to be made.
Be caref
ul when cutting out the template. If you cut the Template properly, the
speaker will be a perfect fit.
3. If there is a cosmetic panel where the speaker will be mounted, we recommend
using a utility knife to carefully cut a hole in it. Confirm the cut by plac
ing the speaker
in the hole. You may modify the holes as necessary.
4. If it will be necessary to cut steel, reinstall the cosmetic panel in place and use
the hole you have previously cut as a template. This will help to insure proper
cutting and a good fit. M
ark the location for the speaker mounting screws, remove
the panel and drill the screw holes. When finished you may replace the panel.
5. After cutting and drilling all holes, inspect the mounting areas for any metal
burrs or rough edges. File any area that may interf ere with the mounti
ng of the
speaker.
6. Clean any metal shavings form the mounting area and check for areas in which
water may enter the speaker cavity. Treat the area for water protection when
necessary.
Make sure your source unit (Cassette, CD, DAT, DVD, etc.) is turned off while
connecting the spea
ker terminals. Turn on the various components and slowly
advance the volume. Remember to check and recheck all connecti ons to insure
proper use.
4