QUALITY, RLIABILITY, & PURE BLISS ACIS MATCHED COMPONENT SYSTEM ACIS52 / ACIS62 / ACIS63 OPERATING INTSTRUCTIONS PLEASE RETAIN MANUAL FOR FUTRE USE AND REFERENCE
Deprive yourself no further... View our complete line of product at... www.audiobahninc.
Introduction TABLE OF CONTENTS 1. Introducti on.................................................................. 2. Features and Specifications.. ......................................... 3. Wiring and X-Over Design.............................................. 4. Frequency Respanse..................................................... 5. Mounting and Instal lation............................................... 6. Choosing a Location...................................................... 7.
Features and specifications FEATURES WOOFER TWEETER Custom Tool Cast Aluminum Basket Custom Tool Cast Aluminum Mounting Plate Chrome Plated Magnetic Plates High Temp Neodymium Ring Magnet High Grade Strontium Ring Magnet Ferro Fluid Used For Dampening Resonance Gray Polyurethane Half Roll Rubber Edge FEA Reverse Polyurethane Edge Gray Woven Glass Fiber Cone Custom FEA 1" Concave Aluminum Dome 2 Layer CCAW 4 Ohm Voice Coil 2 Layer CCAW 4 Ohm Voice Coil High-Temp Coating Glass Fiber For mer Hi
Wiring and X-over Design ASSEMBLY MANUAL ACIS-52 ACIS-62 Crossover C1 R1 R3 R2 C2 L1 Tweeter R4 L2 Woofer C3 AMP -12V Remote +12V ACIS-63 C1 R1 Crossover R3 R2 C2 C3 L1 R4 Tweeter R5 Mid-range R6 L2 C4 Woofer L3 AMP -12V R4 Remote L4 +12V C5
WIRING Audiobahn recommends using at least 18-gauge with your new speaker system. Thinner gauge wire may easily be severed and can cause damage to your system should any bare wire come in contact with the vehicles chassis. Make sure that your audio system is off while installing and connecting your new Audiobahn speakers. Failure to do so could result in damaging the speaker beyond repair. Be sure to route the wires to the speakers with the insulated terminals ending at the speaker.
Frequency Respanse Audiobahn ACIS-52 Component Frequency Response Audiobahn ACIS-62 Component Frequency Response Audiobahn ACIS-63 Component Frequency Response
Mounting and Installation ASSEMBLY MANUAL ACIS-52 ACIS-62 ACIS-63 Tweeter Mid-range 3.9in dia (100mm) 2in dia (50mm) Screws Screws Woofer Woofer 4.6in dia (116mm) Screws 5.
INSTALLATION NOTE: Audiobahn strongly recommends that you operate your system at low volumes prior to the completed installation of your Audiobahn speakers. This will allow a test of the speaker before securing it to its permanent location. CAUTION: Make sure that all speaker wiring is fully protected from cuts, tears and possible wear. All short circuits developing as a result could severely damage the source unit or possibly the amplifier.
SECURING THE SPEAKER Once you have tested your system and have confirmed that it is operating properly, turn off your system and prepare for the final mounting of the speakers. 1. Position the speaker into the mounting hole and reconfirm the correct mounting location and hole placement. Screw clips are provided to insure a snug fit. Place screw clips over the metal surface and line up the hole with the hole you have previously drilled.
CHOOSING A LOCATION It is always best to plan the complete installation prior to attempting to install any product. The routing of wires, power connections and mounting locations should be planned first. As with any car stereo installation, all work performed should be checked thoroughly and carefully prior to the operations of the system. The placement of your Audiobahn speakers within your vehicle will greatly affect the overall performance of your audio system.
TROUBLE SHOOTING In the event that your Audiobahn speakers appear to require service we ask that you first do a little trouble shooting to determine if the problem is actually the speaker or a problem located in a different part of the vehicle such as the amplifier, wiring, fusing or possibly the source unit.
Investigate the layout of your automobile thoroughly before drilling or cutting. Take care when you work near the gas tank, gas lines, hydraulic lines and electrical connections. Do not use the product un-mounted. Attach this system securely to prevent damage, particularly in the event of an accident. Do not mount the system so that wire connections are unprotected or are subject to pinching or damage from nearby objects.
Technical Assistance(800)488-8595 /tech@audiobahninc.com WARRANT INFORMATION Congratulation on the purchase of your Audiobahn audio equipment! Audiobahn produce are manufactured with the highest quality components and most advanced technology available. Because of this we recommend that you have your new Audiobahn products installed by a factory trained Authorized Audiobahn Retailer.
NOTES: