Technical data

Chapter 4 Deployment Manual VIPA System 300S SPEED7
4-34 HB140E - CP - RE_343-1EX71 - Rev. 09/46
In this tab the general connection parameters are listed, which identify the
local connection end point.
This entry is identical to the entry of the connection table. The value may
always be changed. Please also regard to adjust the ID parameter of the
call interface of the FC.
Note!
If a CP is exchanged by another one, this must at least provide the same
services and must at least have the same version level. Only this can
guarantee the connections configured via the CP to remain consistent and
useable.
This field contains the name of the connection. The name is generated by
the system and may be changed on every time.
Here is the CP listed, which should be used for connection. With the button
[Route] the appropriate CP may be selected for communication.
Do not select the 1. CP of the route for communication connections. The 1.
CP is always the Ethernet-PG/OP channel, which does not
support
configurable connections.
If activated the connection to the partner is active established by the local
station. Here the partner is to be specified in the tab "Addresses".
At an unspecified connection the connection is passive established.
Here the parameters
ID and LADDR for your user program are shown.
Both are parameters, which are to be preset if you use the FC 5 and FC 6
(AG_SEND, AG_RECEIVE). Please always use the VIPA FCs, which you
may receive from VIPA.
The Addresses tab displays the relevant local and remote address
information as proposed values. Depending on the kind of communication
the address information may remain unspecified.
Ports res. port addresses are defining the access point to the user
application within the station/CPU. These must be unambiguous. A port
address should be within the range of 2000...65535. Remote and local
ports may only be identical with one connection.
ISO-on-TCP and ISO transport support TSAP lengths (Transport Service
Access Point) of 1...16 Byte. You may enter the TSAP in ASCII or
hexadecimal format. The calculation of the length happens automatically.
General information
ID
Name
Via CP
[Route]
Active connection
establishment
Block parameters
Addresses
Ports
TSAP