Technical data

Chapter 4 Deployment Manual VIPA System 300S SPEED7
4-32 HB140E - CP - RE_343-1EX71 - Rev. 09/46
The ID is the link to your PLC program. The ID must be identical to the ID
of the call interface of the FB/SFB VIPA handling block.
As soon as you click at [Default], the ID is reset to system generated ID.
In this part of the dialog window the connection path between the local and
the partner station may be set. Depending on the linking of the modules the
possible interfaces for communication are listed in a selection field.
With this button a dialog window is opened, which shows address
information about the local and partner station. The parameters may also
be changed.
With Siemens S7 connections a TSAP is automatically generated of the
connection resource (one-way/two-way) and state of place (rack/slot
respectively system internal ID at PC stations).
The connection resource is part of the TSAP of the local station
respectively of the partner. Not every connection resource may be used for
every connection type. Depending on the connection partner and the
connection type the range of values is limited respectively the connection
resource is fix specified.
With deploying of Siemens S7 connections the operating may be
determined by deployment of the FB/SFB VIPA handling blocks in the user
program. To use this blocks configured communication connections are
always necessary in the active station.
More about the usage of these blocks may be found in the manual
"Operation list" of your CPU.
The following blocks may be used with Siemens S7 connections:
FB/SFB Name Description
FB/SFB 8 USEND Uncoordinated data transmission
FB/SFB 9 URCV Uncoordinated data reception
FB/SFB 12 BSEND Sending data in blocks
FB/SFB 13 BRCV Receiving data in blocks
FB/SFB 14 GET Remote CPU read
FB/SFB 15 PUT Remote CPU write
FB 55 IP_CONFIG Programmed communication Connections
Block parameters
Local ID
[Default]
Connection path
[Address details]
TSAP
Connection
resource
Operating mode