Technical data

Manual VIPA System 300S SPEED7 Chapter 4 Deployment
HB140E - CP - RE_343-1EX71 - Rev. 09/46 4-25
The following approach requires that the Ethernet CP 343S-NET - SPEED-
Bus is available online, i.e. you assigned an IP address and subnet mask
via a hardware configuration and the project engineering PC is in the same
IP number circle. For more information see "Access to the Ethernet PG/OP
channel and website..." above.
• Adjust the following setting in the SIMATIC manager at Options >
PG/PC interface...: TCP/IP -> Network card...Protocol RFC 1006.
• Change to your project in the hardware configurator and start the
transfer with PLC >
Download to module.
• Select the favored CP 343-1 and type as "address" the configured IP
address.
Before the transfer takes place you receive an error message that the
"Online module" is different from the "Offline module". Ignore this
message and start the transfer with [OK].
Now you may access the Ethernet CP 343S-NET - SPEED-Bus via your
project and configure the favored connections for the CP 343-1 with
NetPro.
Provided that no new hardware configuration is transferred to the CPU, the
given Ethernet CP 343S-NET - SPEED-Bus is permanently stored in the
project as transfer channel.
Configure CPU via
Ethernet with
CP 343 - SPEED-Bus