Technical data

Manual VIPA System 300S SPEED7 Chapter 4 Deployment
HB140E - CP - RE_343-1EX71 - Rev. 09/46 4-21
The following text describes the approach of the project engineering in the
hardware configurator from Siemens at an abstract sample.
The project engineering is separated into the following parts:
• Project engineering of the CPU as CPU 318-2DP (318-2AJ00-0AB00
V3.0)
• Project engineering of the real plugged modules at the standard bus
• Project engineering of the Ethernet PG/OP channel. When using CPU
31xSN/NET project engineering and connecting the CP part as Siemens
CP 343-1EX11
• Project engineering and connecting of every Ethernet CP 343S-NET -
SPEED-Bus at the standard bus as 343-1EX11 from Siemens
• Project engineering of every SPEED-Bus module as virtual Profibus
network. Here the SPEEDBUS.GSD is necessary.
Standard bus (serial)SPEED-Bus (parallel)
CPU 31xS
DIDO
Ethernet
CP 343
DI DO DIO AI AOAIDIO
CP343 (CPU 31xSN/NET)
Ethernet PG/OP
• Start the hardware configurator from Siemens with a new project and
insert a profile rail from the hardware catalog.
• Place the following Siemens CPU at slot 2:
CPU 318-2DP (6ES7 318-2AJ00-0AB0 V3.0)
• Configure a possibly existing internal DP master of your SPEED7-CPU
via the internal DP master of the CPU 318-2DP. Leave
MPI/DP of the
CPU 318-2DP in MPI mode. The
Profibus mode is not supported.
Module
CPU 318-2
DP
MPI/DP
Standard bus
Slot
1
2
X2
X1
3
Standard bus (serial)SPEED-Bus (parallel)
CPU 31xS
DIDO
Ethernet
CP 343
DI DO DIO AI AOAIDIO
Ethernet PG/OP
CP343 (CPU 31xSN/NET)
Steps of project
engineering
Hardware
Project
engineering CPU
as CPU 318-2DP