Technical data

Chapter 3 Hardware description Manual VIPA System 300S SPEED7
3-4 HB140E - CP - RE_343-1EX71 - Rev. 09/46
The CP 343S-NET carries a number of LEDs that are available for
diagnostic purposes on the bus and for displaying the local status. These
give information according to the following pattern over the operating
condition of the CP:
PWR
green
RUN
green
STOP
yellow
SF
red
L/A
green
S
green
Meaning
○ ○ ○ ○ ○ ○
CP is not power supplied, or there may be a defect.
● ● ○ ●
X
X
Start-up (Communication via SPEED-Bus)
● ● ○ ○
X
X
The CP is in RUN with a loaded project. The
communication by configured connections is enabled.
● ○ ● ○
X
X
CP is in STOP, the communication by configured
connections is disabled or CP has no project and
may exclusively be accessed by the MAC address.
●
X
X X
●
X
CP is physically connected to Ethernet.
●
X
X X
☼
X
Shows communication via Ethernet (activity)
●
X
X X
○
○
There is no physically connection to Ethernet.
●
X
X X X
●
Speed: 100MBit
●
X
X X X
○
Speed: 10MBit
on:
●
off:
○
flashing:
☼
irrelevant:
X
The following operating modes can be set at the Ethernet CP 343S-NET by
means of the operating switch:
RUN
STOP
• RUN
The CP is switched to RUN with the following behavior:
- State RUN is indicated by LED
- Configured connections are established
• STOP
The CP is switched to STOP with the following behavior:
- State STOP is indicated by LED
- Established connections are blocked
- Project engineering and diagnostics are possible
- PG channel routing remains exist
LEDs
Operating mode
switch