Installation manual

Front Panel

SYSTEM

CODE SWITCH

(Momentary switch accessible through panel)

LED (Bi-color: red when power is applied, green when any zone is on)

The front panel LED on the PX-700 indicates that the unit has power

and that at least one Zone is on in the System. If the LED is on (in any

color), the unit is powered. If the LED is red, no Zones are on in that

System. If the LED is green, at least one Zone is on in the System.

When you first apply power to the PX-700 the LED will be red. After

completing the power-on sequence (about 6 seconds), the LED will turn

green for approximately 5 seconds, then back to red. This indicates that

the PX-700 is ready for operation or programming.

AC P

OWER SWITCH (Push button switch)

The PX-700 front panel power switch is used to turn on and off the

main power to the unit. With the PX-700 plugged into an outlet, when

the switch is in the

IN position, power is applied to the unit. When the

switch is in the

OUT position, power is not applied to the unit. The

power state can be determined by looking at the front panel LED.

THE FRONT PANEL POWER SWITCH DISCONNECTS ONLY THE

LINE

SIDE OF THE AC SUPPLY WHEN IT IS IN THE OFF POSITION.

TO COMPLETELY DISCONNECT THE UNIT FROM THE AC SUPPLY,

THE POWER CORD MUST BE UNPLUGGED FROM EITHER THE

UNIT OR THE OUTLET.

IR W

INDOW (Receives IR commands, controls Zone 6, active only on

System 1. Also used to learn IR)

PC LINK JACK (mono

⁄

" / 3.5mm mini-phone jack)

PRODUCT DESCRIPTION

1.3