Installation manual

RS-232 Port
This port enables direct connection of other RS-232 command systems to
the PX-700 or connection to a PC for IR and system programming. The
programming port is replicated with a mini-jack on the front panel. When
the front panel PC Link is in use, the rear panel connector is inactive.
Switched Outlet
This outlet powers up when the first Zone is turned on, and off when the
last Zone is turned off according to the programming of the Trigger Out in
Installation Manager. Plug a power strip into this outlet then plug the
source equipment into the power strip (300 watts maximum).
WARNING: Do not use this outlet with amplifiers or any com-
bination of components that draw more than 300 watts! The
switched outlet is internally fused. Replace fuse only with the
same type and rating. The PX-700 should be serviced by
qualified service personnel only.
In multiple PX-700 Installations, the Switched Outlet is active only on
System 1.
Power Input
The power input is a standard IEC type 3-prong male connector. Connect
the AC power cord to the rear panel of the PX-700 and then to a properly
grounded AC outlet. Make all of the remaining connections with the power
cord plugged in (for grounding) and the AC power switch Off.
WARNING: The PX-700 has an internal main fuse that should
only be replaced with a fuse of the same type and rating.
The PX-700 should be serviced by qualified service personnel
only.
PHYSICAL INSTALLATION
3.14