Installation manual

Audioaccess remote controllers and decode them at the keypad. Control
data is then sent to the PX-700. No actual IR signal is transmitted to the
PX-700 from the keypad.
☞
NOTE: If a repeater is needed, plan for the addition of a separate IR repeater
next to the keypad or somewhere conveniently located in the room!
For KPS keypads installed outside or in bright rooms, turn off the IR receiver
on the keypad. Set DIP switch #9 on the keypad in the UP position.
Sunlight can slow the operation of the keypad or act as false data.
Noise radiated from manually operated light dimmers also interferes with
the operation of Audioaccess keypads. Maintain at least 4" of space between
keypads and dimmers. If installing them closer is unavoidable, turn off the
IR receiver on the KPS by lifting DIP switch #9. A metal box around the
keypad will also help protect it from interference.
If similar problems occur with the IR Receiver in the ATC, the IR Receiver
should be disabled. Please see the ATC Installation manual for instructions.
Setting the ➤
Keypad DIP
Switches
Audioaccess KPS keypads have a set of 10 DIP address switches. The first
eight of these switches assign each keypad to a specific Zone, Room and
System Code. Two additional switches turn on the IR receiver and add
impedance to the data lines (terminator). It is not necessary to turn off the
PX-700 or disconnect the keypad while changing these switch settings. The
changes take effect when the keypad operates the system.
NOTE: All DIP switch settings are also available in the on-line Help file in
Installation Manager.
Zone Switches
The Zone Code must be set to match the Zone you wish to control. The
Zone switches have these values: switch 1=1, switch 2=2, and switch 3=4.
Add these values together to get totals equal to the Zone numbers. Consult
the Wiring Instructions for specific information on each Project.
PHYSICAL INSTALLATION
3.8