User Manual

Control-X Transmitter Controller
88
29
Switching on
To switch the miniTX or TX2040 on, even through clothing:
• Hold the Control-X within 20cm (8") of the transmitter.
• Press and hold the ON button and slowly wave the
Control-X in front of the transmitter.
The green indicator illuminates
and the display shows:
tr On
• Release the ON button.
The green indicator stays illuminated if a signal is being
received from the transmitter, and the display shows the
frequency.
For example:
MHz
856.575
FREQUENCY
Switching off
• Hold the Control-X within 20cm (8") of the transmitter.
• Press and hold the OFF button and slowly wave the
Control-X in fromt of the transmitter.
The red indicator illuminates
and the display shows:
tr OFF
• Release the OFF button.
The red indicator stays illuminated
and the display then shows:
no SIG
This confirms that the transmitter has been switched off.
Checking whether the miniTX or TX2040 is switched on
You can use the Control-X to check the status of the
transmitter, without switching it on or off, as follows:
• Hold the Control-X more than 20cm (8") away from the
transmitter, and press and release the ON button.
• Move the Control-X within 20cm (8") of the transmitter.
If the transmitter is operating the green indicator will be
illuminated and the display shows the frequency.
For example:
MHz
856.575
FREQUENCY
If the transmitter is not operating the red indicator will be
illuminated.
The display shows:
no SIG
Displaying the frequency of any
transmitter
. . . . . . . . . . . . . . . . . . . . . . . .
The Control-X can be used to display the frequency of any
Audio Ltd or third-party transmitter.
Displaying transmitter frequency
• Bring the transmitter within 5cm (2”) of the Control-X.
• Hold down the ON button.
The display shows the transmitter
frequency; for example:
MHz
856.575
FREQUENCY