User Manual

HX2040 Hand-Held Transmitter
88
24
Otherwise the display will show:
Error
• Repeat the previous steps if an error message is
displayed, moving the SwitchiR closer to the infra-red
port.
Checking the battery status
• Press MENU.
• Press a three times until
the display shows:
TxRx
BAtt
• Align the front of the SwitchiR with the infra-red port on
the transmitter and press OK.
The display will show the
current battery status:
Tx
1.25v
The battery level can also be checked from the receiver; see
the appropriate instructions for the receiver.
Infra-red disable
. . . . . . . . . . . . . . . . . . . . . . . .
You can protect the HX2040 from an accidental change
of settings, such as in a live performance, by disabling
the infra-red port on the transmitter. This will prevent
all communication to the transmitter until the battery is
disconnected and reconnected.
Disabling the infra-red port
• Press MENU.
• Press v twice.
The display
will show:
TxRx
dISABLE
TxRx
Ir ?
• Align the front of the SwitchiR with the infra-red port on
the transmitter and press OK.
If the command was received
successfully the display will show:
Tx
Ir OFF
Note: Once the infra-red port has been disabled, any
subsequent interrogation of the transmitter will give an Error
display; this is not a fault.
Fitting the microphone capsule
. . . . . . . . . . . . . . . . . . . . . . .
The HX2040 transmitter uses high quality interchangeable
condensor capsules from the Schoeps™ Colette range. The
HX2040 is compatible with the full range of capsules and
accessories in this range.
The capsule mounting has a unique gel-based suspension to
minimise handling noise.
To fit a capsule
• Unscrew the metal windscreen from the top of the
transmitter.
• Screw the capsule into place taking care not to cross-
thread the capsule or over-tighten it.
• Replace the windscreen.