System 8 VHF Wireless System Installation and Operation POWER SYSTEM 8 RF PEAK ATW-801 UniPak® Transmitter System ATW-801/G Guitar System ATW-801/H Headworn Microphone System ATW-801/H92 Miniature Headworn Microphone System ATW-801/H92-TH Miniature (beige) Headworn Microphone System ATW-801/L Lavalier Microphone System ATW-802 Handheld Microphone System
System 8 Installation and Operation This device complies with part 15 of the FCC Rules. Operation is subject to the condition that this device does not cause harmful interference. A copy of the declaration of conformity can be found on the internet at www.audio-technica.com. This device complies with INDUSTRY CANADA R.S.S. 210, en conformité avec IC: RSS-210/CNR210.
System 8 Installation and Operation Receiver Controls and Functions 1a 2 3 1b POWER 4 SYSTEM 8 RF POWER SYSTEM 8 RF PEAK Figure A — Front Panel Controls and Functions 1. ANTENNAS: Position the “signal” antenna (1a) and “ground” antenna (1b) as shown to the right and above right. Fully extend both antennas by pulling on the endcaps. 2. RF INDICATOR: Lights to show presence of transmitter signal. 3. POWER INDICATOR: Lights when power is supplied to the receiver. 4.
System 8 Installation and Operation Transmitter Setup Controls and Functions Battery Selection and Installation Two alkaline AA batteries are recommended. When inserting the battery, observe correct polarity as marked inside the battery compartment. Gain Trimmer L H LEVEL Battery Compartment LR6,AA Screwdriver LR6,AA SYSTEM 8 Figure C — Handheld Transmitter Handheld Transmitter Battery Installation 1.
H L MIC L Instrument Trimmer (INST) INST H System 8 Installation and Operation PUSH LR6,AA LR6,AA Microphone Trimmer (MIC) Screwdriver Battery Compartment Figure D — UniPak Transmitter ® UniPak® Transmitter Battery Installation 1. Slide off the battery cover as shown in Figure D. 2. Carefully insert two fresh AA alkaline batteries, observing polarity markings. 3. Replace the battery cover (Fig. D).
System 8 Installation and Operation System Operation Turn down the receiver volume control and the mixer/amplifier level before starting up the wireless system. Do not switch on the transmitter yet. Receiver on... Plug the power supply into an AC power source. The green Power indicator on the front panel will light. Transmitter on... When the transmitter is switched on, the receiver’s amber RF signal indicator will light. The transmitters have a soft-touch power switch.
System 8 Installation and Operation System Operating Frequencies Application • Freq. Code Freq. (MHz) Traveling frequencies: T2 (Normally work anywhere in the U.S.A. and T3 Canada.) Not all frequencies available in all areas T8 outside the US. Please check with local regulations. 169.505 170.245 171.905 Systems on these frequencies may be combined for up to three simultaneous operating channels.
Audio-Technica U.S., Inc. 1221 Commerce Drive, Stow, Ohio 44224 USA +1 (330) 686-2600 Audio-Technica Limited Old Lane, Leeds LS11 8AG England +44 (0) 113 277 1441 Audio-Technica (Greater China) Limited Unit K, 9/F., Kaiser Est. (Ph.2) 51 Man Yue St. Kowloon, HK. +852-2356-9268 Audio-Technica (S.E.A.) Pte. Ltd. No 1 Ubi View, #01-14 Focus One, Singapore 408555 +65-6749-5686 Audio-Technica Corporation 2206, Naruse Machida, Tokyo Japan ©2012 Audio-Technica U.S., Inc. audio-technica.
