User's Manual

5. If you do not wish to use the frequency found, you may press the Up or Down arrow. The
Up arrow with scan upwards, the Down arrow will scan downwards, from the frequency
you are on.
6. To set frequency for Receiver Channel 2 (for dual-channel operation), switch Dual-
channel Control Switch to 2 (right position). Repeat steps 1-4 above. Note: Be certain to
select the same Scan Group than you used for Receiver Channel 1.
7. To lock settings and operate unit in dual-channel operation (using two transmitters),
switch Dual-channel Control Switch to Hold (center position). The receiver will return to
normal operation, audio function will be restored and the Dual-channel Control LED
indictor will turn green.
8. If you are using multiple systems, after completing the first receiver's scan and frequency
selection, set its transmitter to the same frequency (see Setting Transmitter Frequency
instructions on page ); leave the transmitter On, and run the next receiver’s automatic
scan function. Always set a receiver-transmitter pair to the same frequency before using
the automatic scan function to select a frequency for the next receiver.
In the event that no more free frequencies are available within the scan group, the
receiver will indicate “END” on the receiver display. In this case, the user should select a
different scan group for both Receiver Channels 1 and 2 and re-scan.
Note: While Channel Selection mode is still active, if the Dual-channel Control Switch is moved
back to Hold position before channel selection is complete, LED will remain red and audio will
remain muted until the control sequence is completed.
Single-channel operation
Setting Receiver Frequency Manually (for single-channel operation)
First…
Turn the power on by moving the Power switch to the 1 position (for single-channel operation).
Switch Dual-channel Control Switch to 1 (left position). Output from Receiver Channel 1 is now
muted.
1. Press Set button. The word “MENU” will appear. Press Up arrow to show current
frequency. Press Set button and frequency will begin to flash; use up and down arrows to
adjust the frequency. Frequency changes in 25k steps. To increase scroll speed, hold
the up or down arrow for more than 4 seconds.
2. When you arrive at desired frequency, press and hold the Set button until the word
“Stored” appears. Frequency (which appears on the screen) is now set.
3. To “back out” of the Manual Frequency Set mode without making a frequency choice,
simply press the Set button once to exit the menu and return the receiver to normal
operation. The word “ESCAPE” will appear in the window, and no changes in frequency
setting will be made; the receiver’s audio output will again be enabled.
To lock settings, un-mute and operate the unit, switch Dual-channel Control Switch to Hold (center
position).
Using the Automatic Scan Function to Set Receiver Frequency
Automatically (for single-channel operation)
First…
Turn the power on by moving the Power switch to 1 (for single-channel operation). Then
switch Dual-channel Control Switch to 1 (left position).
1. Press the Set button to enter the Frequency Selection Menu mode; the world “Menu” will
appear.