User's Manual

4. Use the Up/Down arrows to cycle through functions:
• First arrow up is Manual Frequency Selection Mode;
• second arrow up is Automatic Scan Group 1;
• third arrow up is Automatic Scan Group 2;
• fourth arrow up is Automatic Scan Group 3;
• fifth arrow up is Quit, allowing exit from “Menu” mode.
Dual-channel operation (using two transmitters)
Setting Receiver Frequency Manually
First…
Turn the power on by moving the Power switch to Both (for dual-channel operation). To
set frequency for Receiver Channel 1, switch Dual-channel Control Switch to 1 (left
position).
1. Press Set button. The word “MENU” will appear. Press Up arrow to show current
frequency. Press Set button and frequency will begin to flash; then use up and down
arrows to adjust the frequency. Frequency changes in 25k steps. To increase scroll
speed, hold the up or down arrow for more than 4 seconds.
2. When you arrive at desired frequency, press and hold the Set button until the word
“Stored” appears. Frequency is now set.
3. To “back out” of the Manual Frequency Set mode without making a frequency choice,
simply press the Set button once to exit the menu and return the receiver to normal
operation. The word “ESCAPE” will appear in the window, and no changes in frequency
setting will be made; the receiver’s audio output will again be enabled (when Dual-channel
Control Switch is returned to Hold position).
To set frequency for Receiver Channel 2, switch Dual-channel Control Switch to 2 (right position).
Repeat steps 1-2 above.
To lock settings and operate unit, switch Dual-channel Control Switch to Hold (center position).
Note: While Channel Selection mode is still active, if the Dual-channel Control Switch is moved
back to Hold position before channel selection is complete, LED will remain red and audio will
remain muted until the control sequence is completed.
Using the Automatic Scan Function
to Set Receiver Frequency (dual-
channel operation)
First…
Turn the power on by moving the Power switch to Both (for dual-channel operation). Then
switch Dual-channel Control Switch to 1 (left position).
1. Press the Set button to enter the Frequency Selection Menu mode; the world “Menu” will
appear.
2. Use the Up or Down arrow to reach Scan 1, Scan 2, or Scan 3. Press the Set button once
to select one of these three Scan groups. The word “SCAN1”, “SCAN2” or “SCAN3” will
flash in the LCD window.
3. Press the Up or Down arrow to begin the scan. Press the Up arrow to scan up from
the lowest frequency in the group; press the Down arrow to scan down from the
highest frequency in the group.
4. The first available frequency will flash in the LCD window. To activate this frequency
selection, press and hold the Set button until the word “STORED” appears in the LCD
window.