User's Manual

31 | P a g e
NOTE: Change Figure P: callout should read Power/Mute LED not Power-on LED
Handheld Transmitter Battery Installation
1. While holding the lower body cover (near the LCD window), grasp the upper part of the transmitter
body just below the grille and unscrew it at least four complete turns (Figure N); then slide the lower
body cover down until it stops (Figure P). Once the cover has been lowered, turn the transmitter over to
reveal the battery compartment on the side opposite the LCD window.
2. Observe correct polarity as marked inside the battery compartment and carefully insert two fresh 1.5V
AA alkaline batteries (Figure Q). Insert the first battery and slide it down. Then insert the second battery,
bottom first, into the space remaining. Make certain the batteries are fully seated in the battery
compartment.