User's Manual

28 | P a g e
a2. Hold the Set button again until “STORED” appears in the window. This stores the
standard Preset name with the associated function choices and returns the transmitter to
normal operation.
b.To enter a custom name for a Preset:
b1. At the desired Preset, hold the Set button until the first character blinks.
b2. Using the Up or Down arrow, move through the available characters (see box below)
until the desired character is reached. Touch an arrow button for single steps, or hold it
down to scroll through the characters at increasing speed.
b3. Touch the Set button once to accept the first character and move to the second
character, which now is blinking. Use an Up/Down arrow to find the desired second
character; touch the Set button once to accept it and move to the third position. Repeat
this selection process until the character for the sixth position has been selected. (It is
not necessary to change or step through all six characters before storing the result. At
any point in the process, simply hold the Set button until “STORED” appears in the
window.)
b4. Once the sixth character has been selected as desired, hold the Set button until
“STORED” appears in the window. This stores the custom Name with the associated
function choices and returns the transmitter to normal operation.
Note: If a correction or change is desired while entering characters, simply touch the Set button once
when the sixth (last) character has been reached. The window will flash “ESCAPE.” Touching the Set
button once more will start the name-entry process over at the first character. (To leave any characters as
they are, simply touch the Set 20 button once to skip over them.)
Available transmitter Name character choices (listed in the Up-arrow direction):
A …through… Z,
__ (underscore) … (space),
[ (left bracket) … ] (right bracket),
* … + … -- … /,
0 …through… 9,
| … < … > … ?
To load (recall) a Preset:
1. Touch the Set button once to move to Menu mode. (The window changes to frequency, if Name had
been displayed.)
2. Touch the Up arrow twice to move to “PRESET” in the LCD window.
3. Touch the Set button once. “LOAD” (or “STORE”) appears in the LCD.