SpectraPulse Ultra Wideband Wireless Microphone System ® mtu201 Wireless XLR Desk Stand Set-up and Operation
This device complies with Part 15 of the FCC rules. Operation is subject to the following conditions: (1) This device may not cause harmful interference and (2) This device must accept any interference received, including interference which may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules.
4 5 Contents What’s in the box mtu201 Installation & Operation mtu201 Controls Specifications 3. Connect an Engineered Sound® gooseneck microphone with 3-pin XLRM-type output to the XLRF-type input on the mtu201 XLR Desk Stand Transmitter.
6 7 mtu201 XLR Desk Stand Transmitter Controls 5. Power LED and Low-battery Warning The Power LED on the top of the desk stand transmitter glows blue to indicate the power is on. 1. Battery Selection and Installation The mtu201 Wireless XLR Desk Stand Transmitter operates on two AA batteries (standard alkaline or rechargeable). Please make certain that your batteries are fresh or fully charged. Two AA 1.5V alkaline batteries are included with each desk stand transmitter.
8 Specifications Input connector XLR-female low impedance intended for use with Audio-Technica gooseneck microphone of Engineered Sound series. Bias voltage to mic feed The mtu201 delivers 11.5V DC to the XLR connector in order to power any of the A-T Engineered Sound series microphones. Battery type Two 1.5 volt AA alkaline batteries are included. Rechargeable SANYO brand NiMH AA batteries are recommended; they are included with the available cei007 Charging/Encryption Interface.
