User's Manual

Studio Broadcast System
Page 9 of 13
The Σ button is used to view receivers that are connected to ANY active transmitter
rather than just a single transmitter. This mode is used to test which receivers are most
effective in a given set up, and may also assist in receiver placement.
When the user selects the matrix screen, the system will first check for added receivers;
without interrupting the operation of the active receivers or the audio output. This
gives the user a way to add receivers while the system is in active operation. If the user
plugs in a receiver it will not be active until the system goes through this process.
Pressing the mode swap button switches to Transmitter measurement mode.
4. System QUICK START
 Using a shielded CAT 5 cable (may be used with up to 1,000 feet of cable per
channel) terminated with a standard RJ45 connector, plug the cable into the RJ45
input jack on the rear of at least RP32 receiver. Connect the other end of the CAT
5 cable to the RJ45 input jack on the rear of the MCU3224 main control unit. You
may connect up to 32 RP32 receivers by connecting them into the corresponding
channel output (1-32) found on the rear of the MCU.
You do not need to turn the RP on. It receives power via the CAT 5 cable
from the MCU 3224. The RP display should immediately light and display
the channel output number to which it has been connected on the MCU.
 Apply power to the MCU3224 by connecting at least one IEC cable to AC wall
supply.
 Press the front panel “power” button.
The power light(s) corresponding to the IEC cable input will be visible on the
front panel (one red and one blue), and the GUI screen will illuminate and
enter a “set-up” mode while the system is normalizing and preparing for
operation.