User's Manual

13
*******
007BAUL
*******
007BAUL
FREQ.
:
710-7 14 MHz
BAT T.: LR6, A A
×
2, 3 V
Audio-Technica Corp.
MAD E IN JAPA N
ATW-T 6 0 01 R
FREQ.
:
946-950 MHz
FCC I D: JFZ T60 01S
BAT T.: LR6, A A
×
2, 3 V
Audio-Technica Corp.
MAD E IN JAPA N
ATW-T 6 0 01 S
FREQ.
:
710-7 14 MHz
BAT T.: LR6, A A
×
2, 3 V
Audio-Technica Corp.
MAD E IN JAPA N
ATW-T 6 0 01 R
FREQ.:704-708MHz
CMIITID:********
BATT:LR6,AAx2,3V
Audio-TechnicaCorp.
MADEINJAPAN
IR sync
The product is equipped with an IR sync function. It allows you
to easily congure the product settings from the receiver.
See the receiver's user manual for instructions on how to use
IR sync.
Attaching the product to user's body
The product is equipped with a clip. Use that to attach the product
to a belt, pocket or other piece of clothing that will hold it.
You can reverse the direction
that the input connector faces
by attaching the clip in the
opposite direction.
Pull both sides of the clip rmly
to the outside to remove the
clip from the product.
Troubleshooting
"LOW BATT" is displayed and the unit does not respond to
operation.
→
Are the batteries depleted?
Sound is distorted.
→
Is the product input level set too high?
There is no voice output. The voice output level is low.
→
Are the frequency settings for this product and the
receiver correct?
→
Has the appropriate input level for this product been set?
→
Is the microphone properly connected?
→
Is the volume for an instrument that is connected to the
receiver completely turned down?
There is unwanted noise.
→
Are uorescent lamps, electric appliances, and other
sources of noise kept away from the product or receiver?
→
Is the receiver set up near a source of noise? Noise may
also be generated if power is being taken from the same
outlet as a device that produces a lot of noise.