Owner's Manual

System 9 Installation and Operation
3
1234
CHANNEL
1234
CHANNEL
Receiver Controls and Functions
Figure A — Front Panel Controls and Functions
1. ANTENNAS: Position the “signal” antenna (1a) and
“ground” antenna (1b) as shown to the right and above right. Fully
extend both antennas by pulling on the endcaps.
2. RF INDICATOR: Lights to show presence of transmitter signal.
3. CHANNEL SELECT BUTTON: Soft-touch button selects channel.
4. CHANNEL INDICATOR LIGHTS: Lights to show which channel is
selected. A channel indicator LED will light when power is applied
to the receiver.
5. AF PEAK INDICATOR: Only lights when audio distortion
is present at maximum modulation. Not affected by
position of Volume control.
Figure B — Rear Panel Controls and Functions
1. SQUELCH CONTROL: Adjusts level of noise-muting circuit
(preset at factory but can be adjusted as circumstances warrant).
2. VOLUME CONTROL: Adjusts the audio level at the
1
/
4
" and XLRM
output jacks. Does not affect AF Peak indicator.
3. UNBALANCED AUDIO OUTPUT JACK:
1
/
4
" TS (Tip-Sleeve) or “mono”
phone jack. Use a shielded cable to connect to an unbalanced
4. BALANCED AUDIO OUTPUT JACK: XLRM-type connector. A
standard 2-conductor shielded cable can be used to connect the
receiver output to a balanced microphone-level input on a mixer or
5. POWER INPUT JACK: Connect the DC plug from the
included AC adapter.
6. CORD HOOK: Loop the cord around the cord hook to keep
the DC plug from pulling out accidentally.
PEAK
RF
1234
CHANNEL
MIN.
SQUELCH VOLUME UNBALANCED
BALANCED
DC 12V IN
500mA
MAX. MIN. MAX.
1a 1b
2 53 4
1 2 3 54 6