Owner's Manual
UniPak<llTransmitter Battery Installation
1.
Slide off the battery cover
as
shown
in
Figure
D.
2.
Carefully insert
two
fresh AA alkaline batteries, observing polarity
markings.
3.
Replace
the battery cover
(Fig.
D).
UniPak<llTransmitter
Power/Mute/Battery
Indicator
After the battery
is
installed, press and hold the power button until the
indicator
LED
turns green
(Fig.
E).
If the indicator
LED
does not light up
when the power button
is
pressed, the batteries are installed incorrectly
or they
are
dead. The indicator
LED
will flash to show low-battery
condition.
UniPak<llTransmitter Channel Selection
Before turning on
the
transmitter, use DIP Switches 1 and
2,
locat
ed
inside the UniPak<llTransmitter,
to
select the desired channel.
1.
To
access the DIP Switches, slide
off
the battery cover.
2.
To
achieve the desired channel, use the provided screwdriver to
change the
DIP switch configurations
as
follows:
Channel
1:
Switches 1 and 2
"up"
Channel
2:
Switch 1
"up";
Sw
itch 2
"down"
Channel
3:
Switch 1
"down";
Switch 2
"up"
Channel 4: Switches 1 and 2
"down"
3.
Replace the battery cover.
UniPak®Transmitter
Mute
Function
With the transmitter on, a slight touch of the Power/Mute button will
toggle between muted and unmuted operation.
Red
indicator LED shows
muted operation. Green indicator
LED
shows unmuted operation.
UniPak®Transmitter
Input
Connection
Connect
an
audio input device (microphone or guitar cable)
to
the
audio input connector on the top of the transmitter. A number
of
Audio-Technica professional microphones and
cab
les are available
separately, pre-terminated with a
UniPak® input connector (see
www.audio-technica.com).
UniPak
<ll
Transmitter Antenna
The UniPak® transmitter includes a permanently-attached flexible
antenna. For b
est
result
s,
allow the antenna to hang freely and
full length from
the
transmitter.
If
the received signal is marginal,
experiment
with
different transmitter positions on your body
or
in
strument; or
try
repositioning the receiver.
Do
not attempt
to
remove, replace or change the length
of
the transmitting antenna.
5
System 9 Installation and Operation
Figure D -
UniPa~
Transmitter
11
\.
I Switch
Config•retion
for
Channel
Selection
I
I
I
I
I
I
@
1\
ll1
<
ll1
~
m
s:
•
/
€)
Ill
c:
Q.
o·
,Ito
~
';1'
~·
Ill
l.l
/
/
/
/
/
/
/
/
/
/
/
/
/
/
/
/
~-
Channel Configuration Label
·······Microphone
Trimmer
(MIC)
- - · Channel Selection DIP Switches
----------
--·
Screwdriver
Figure E -
UniPa~
Transmitter
Antenna
Power/Mute
Button
Indicator
LED
(Power/Mute/Battery)
Input
Connector