Owner's Manual
4
System 9 Installation and Operation
Transmitter Setup Controls and Functions
Battery Selection and Installation
Two
alkaline AA batteries
are
recommended. When inserting the battery,
observe
correct
polarity
as
marked
inside
the
battery
compartment.
Figure C -
Handheld
Transmitter
Handheld Transmitter Battery Installation
1.
While holding the upper part of the transmitter body just below the
ball-screen, unscrew the lower body cover
and
slide
it
off
to
expose
the battery compartment (Fig.
C).
2.
Carefully insert
two
fresh AA alkaline batteries, observing
polarity markings.
3.
Screw the body back together.
Do
not
overtighten.
Handheld Transmitter Battery Condition Indicator
After the batteries are installed, press and ho
ld
the Power/Mute switch
on the bottom
of
the handheld transmitter until the indicator
LED
turns
green.
If
the indicator
LED
does not light up when the
Po
wer/Mute
sw
itch is pressed. the batteries
are
installed incorrectly or they are
dead.
The
indicator
LED
witt flash to
show
tow-battery condition.
Handheld Transmitter Channel Selection
Before turning on
th
e transmitter, use DIP Switches 1 and
2,
located
inside the Handheld Transmitter, to select the desired channel.
1.
To
access the DIP Switches, hold the upp
er
part of the transmitter
body just below the
batt
-screen, and unscr
ew
the lower body cover
and
slide
it
off.
2.
To
achieve the desired channel, use
th
e provided screwdriver to
change the
DIP switch configurations as follows:
Channel
1:
Switches 1 and 2
"up"
Channel2: Switch 1
"up";
Swit
ch
2
"down"
Channe
l3
: Switch 1
"down";
Switch 2
"up"
Channel4: Switches 1 and 2
"down"
3. Screw the body
back
together. Do
not
overtighte
n.
Channel
Se
lection
//
DIP Switches /
I
/
/
Channel Configuration
Label
/
/
/
/
/
Switch
Configuration
for
Channel
Selection
/
/
/
---
---
---
Gain
Trimmer
Battery
Compartment
Screwdriver
Indic
ato
r LED
(Powe
r/Mut
e/Battery)
Power/Mute
Switch
Handheld Transmitter
Mute
Function
With
the
transmitter on, a slight touch
of
the power
swi
t
ch
will toggle
between m
ut
ed and unmuted operation.
Red
indicator
LED
shows
muted operation. Green indicator
LED
s
how
s unmuted operation.