User Manual

ATM350
LEGEND
200 Hz
1 kHz
5 kHz
8 kHz
SCALE IS 5 DECIBELS PER DIVISION
240˚
180˚
210˚
270˚
300˚
330˚
0˚
150˚
120˚
90˚
30˚
60˚
12" or more on axis
LEGEND
Frequency in Hertz
Response in dB
10 dB
100
50
200
10k
5k
1k
500
2k
20k
Roll-off
frequency response: 40– 20,000 Hz
polar pattern
Fixed-charge back plate, permanently
polarized condenser
Cardioid
40-20,000 Hz
80 Hz, 12 dB/octave
–49 dB (3.5 mV) re 1V at 1 Pa
50 ohms
149 dB SPL, 1 kHz at 1% T.H.D.
122 dB, 1 kHz at Max SPL
67 dB, 1 kHz at 1 Pa
11-52V DC, 3.5 mA typical
Flat, roll-off
Microphone: 14.5 g (0.5 oz)
Power module: 81.2 g (2.9 oz)
Microphone: 37.8 mm (1.49") long,
12.2 mm (0.48") diameter
Power module: 92.9 mm (3.66") long,
18.9 mm (0.74") diameter
Power module: Integral 3-pin XLRM-type
4.0 m (13.1') long (permanently attached
to microphone), 3.2 mm (0.13") diameter,
2-conductor shielded cable with
TA3F-type connector
UE-O omnidirectional (360°)
UE-H hypercardioid (100°)
M36
AT8542 power module; AT8418 UniMount
®
microphone instrument mount; AT8468
violin mount; soft protective pouch
Element
Polar pattern
Frequency response
Low frequency roll-off
Open circuit sensitivity
Impedance
Maximum input sound level
Dynamic range (typical)
Signal-to-noise ratio
1
Phantom power requirements
Switch
Weight
Dimensions
Output connector
Cable(s)
Optional interchangeable elements
Audio-Technica case style
Accessories furnished
In the interest of standards development, A.T.U.S.
offers full details on its test methods to other industry
professionals on request.
1 Pascal = 10 dynes/cm
2
= 10 microbars = 94 dB SPL
1
Typical, A-weighted, using Audio Precision System One.
Specications are subject to change without notice.
Audio-Technica U.S., Inc., 1221 Commerce Drive, Stow, Ohio 44224
Audio-Technica Limited, Old Lane, Leeds LS11 8AG England
©2010 Audio-Technica U.S., Inc. audio-technica.com 0001-0173-01
Specicationsmicrophone shall include a power module, an instrument mount, a violin
mount and a soft protective pouch.
The microphone shall also be available in a wireless model with a 1.4 m
(55") miniature cable terminated with a locking 4-pin connector for use
with Audio-Technica UniPak
®
body-pack transmitters. No power module
shall be required or included with the wireless model. The wireless model
dimensions, polar pattern, and included instrument mount and violin
mount shall be identical to those of the wired model.
The Audio-Technica ATM350 [ATM350cW-wireless] is specied.
381