User Manual

16
Using the product
Ear detection
The product has a built-in sensor.
It can detect when the product is removed from or worn in the ear, and automatically perform operations during music
playback and calls.
Turning on the ear detection (off at the time of purchase)
1. Long touch (about 6 seconds) the touch sensor area on the L (left) side headphone while music is paused.
• A confirmation tone and voice guidance are played.
• To turn off this feature again, perform this operation again.
• If the ear detection is on, an ear detection tone is played when the product is put into the ear.
Operations during music playback
When you remove a headphone from your ear, music is paused automatically, and music resumes when you are wearing
both headphones again.
• Begin music playback by touching the touch sensor or using the connected Bluetooth device.
• If you remove one or both headphones, the music will pause. To resume playback, wear both headphones.
Pauses when removed Plays when worn
• When wearing the product, check that the indicator lamps are flashing (ready to use), and then wear the product
properly on your ears.
• The ear detection may not work if the product is not worn correctly.