User Manual
Table Of Contents
- Introduction
- Package contents
- Safety precautions
- Notes on use
- Part names and functions
- Preparation for use
- Placing the platter
- Setting up the turntable
- Assembling the tonearm
- Tonearm balance and tracking force
- Setting tonearm balance
- Setting tracking force
- Setting the anti-skate adjustment
- Installing/removing the dust cover
- Setting output selector switch
- Connecting to connectable equipment (active speakers, amplifiers, etc.)
- Connecting the AC adapter
- Playing a record
- Care
- Replacing the stylus
- Replacing a cartridge
- Replacing the belt
- Adjusting the overhang
- When the turntable is moved
- Troubleshooting
- Dimensions
- Specifications
10
Playing a record
Before playing a record
1. Remove the cartridge’s protector.
• If the tonearm is fixed to the tonearm rest, remove the clamp.
Protector
2. Place the record on the rubber mat so that the center hole aligns
with the spindle.
• If playing a 45 RPM record, attach the 45 RPM adapter (see the diagram
below).
At 33-1/3 RPM
Record
45-RPM
adapter
At 45 RPM
Playing a record
Lower the volume of the amplifier, speakers, etc. sufficiently.
1. Turn the power switch on.
2. Use the control knob to select the speed.
• Select “33” for a 33-⁄ RPM record, or “45” for a 45 RPM record.
• The platter begins to rotate.
3. Raise the tonearm by lifting the tonearm lift control lever to the
UP position.
4. Position the tonearm over the desired location (groove) on the record.
5. Lower the tonearm by moving the tonearm lift control lever to the
DOWN position. The tonearm descends slowly onto the record
and play begins.
• Alternatively, you can skip steps 2 to 4, and use your fingers to lift the
headshell, move the tonearm over the desired location on the record, and
then place the headshell down to begin playing the record.
• Do not subject the product to strong impact during playback.