Owner`s manual

8
Specifications
Type Belt drive turntable, fully automatic
Platter Aluminum
Motor DC servo-controlled
Speeds 33
1
/
3
RPM, 45 RPM
Wow and flutter Less than 0.25% (WTD) @ 3K Hz (JIS)
Signal-to-noise ratio 50 dB
Cartridge Integral Dual Magnet
stereo cartridge
with diamond stylus
Output level
Pre-amp “PHONO 2.5 mV nominal at 1 KHz, 5 cm/sec
Pre-amp “LINE” 200 mV nominal at 1 KHz, 5 cm/sec
Power 120V AC, 60 Hz, 3W
Dimensions 14.17" (360 mm) W x 3.82" (97 mm) H x
14.06" (357 mm) D
Net weight 6.6 lbs. (3 kg)
Furnished accessories Dual RCA (female) to
1
/
8
" (3.5 mm) mini-
plug (male) stereo adapter cable; dual
RCA (female) to
1
/
8
" (3.5 mm) mini-plug
(female) stereo adapter cable; USB cable;
45 RPM adapter
Replacement stylus ATN3600L
Tips For Better Performance
When opening or closing the turntable cover, handle it
gently, moving it either at the center or equally from
both sides.
Do not touch the stylus tip with your fingers; avoid
bumping the stylus on the turntable mat or a
record’s edge.
Clean the stylus tip frequently, using a soft brush with
a bac
k-to-front motion only.
If you use a stylus cleaning fluid, use it very
spar
ingly.
Wipe the dust cover and turntable housing gently with
a sof
t cloth. Use only a small amount of mild detergent
solution to clean the turntable and dust cover.
Never apply harsh chemicals or solvents to any part of
the turntable system.
Prior to moving the turntable, always unplug it from the
AC outlet and fasten the tone arm on the tone arm rest
with the vinyl twist-tie.