Specifications

English
9
Troubleshooting
Turntable operates but emits no sound or not enough sound.
 
2. The tone arm is in the lift position. Lower the tone arm.
 
selected, tape monitor on, speakers switched off, etc. Verify
proper control settings.
 
replace if necessary.
 
Check the cartridge and adjust if necessary.
6. The pre-amp selector switch is set in the wrong position. Verify
that it is set for proper output to match mixer/amplifier.
  
Aux/Line input.
- Very loud/distorted sound: Line Out setting into a
Phono input.
Turntable operates but stylus “skips” across record.
 
2. The tracking force is set too light. Set tracking force per cartridge
manufacturer’s recommendation.
 
out on record). Set tracking force per cartridge manufacturer’s
recommendation.
 
same value as cartridge tracking force.
 
 
solid surface.
Record sounds too fast or too slow.
1. Turntable is set for wrong speed. Make proper speed selection for
record type being played with platter speed buttons.
 
 
Moving pitch adjust slider produces no effect.
If the LED next to the pitch adjust slider center detent position remains



Strobe dots are difficult to see and/or stylus illuminator is very
dim.
1. Excessively bright or fluorescent light interferes with strobe
 
shield it from bright light.
 
Disconnect AC power cord and reset the voltage selector switch
 
 
the platter up to proper speed.)
 
moving it either at the center or equally from both sides.
 
the stylus on the turntable mat or a record’s edge.
 and a back-
to-front motion.
 sparingly.
 
cloth. Use only a small amount of mild detergent solution to
clean the turntable and dust cover.
 Never apply harsh chemicals or solvents to any part of the
turntable system.
 
outlet and lock the tone arm on the tone arm rest.
Tips For Better Performance