Specifications

8
Mechanical Assembly
1. Unpack the cartridge and carefully remove its stylus assembly.
Place the stylus assembly out of harm’s way.
Mount the new cartridge to the headshell assembly.
Use the mounting hardware supplied with the new cartridge.
Tighten the mounting screws until just snug.
 
interference with the mounting hardware. The stylus assembly
should click into place. Make certain the new cartridge is properly
positioned in the headcase assembly per the manufacturer’s
instructions. Again remove the stylus assembly for safekeeping.
Electrical Connections
 
 
cartridge with the slip-on lugs provided on the headshell wiring.
 
the terminals will damage the internal cartridge wiring.
 
connected to the monaural output terminal and the left and right
ground leads should be connected to the ground terminal.
 
careful not to damage the stylus. The stylus assembly should click
 
taking care not to damage the stylus assembly.

force and anti-skate based on the cartridge’s specifications.)
Figure 8 – Electrical Connections
Left Output
(White)





(Blue)
Installing a Cartridge