Specifications

English
5
Initial Setup
Unpacking
Carefully unpack the turntable and verify that the following parts are
included and intact:
  
  
  
  
foam packaging)
  
  
  
  
  
  
stereo adapter cable
  
stereo adapter cable
  



Assembling the Turntable
The AT-LP120-USB requires some assembly before first use.

complete.
Setting the Voltage Selector Switch


top of the housing deck, under the platter. Set the switch according


Figure 4 – Voltage Switch
Setting the Pre-amp Selector Switch

phono pre-amplifier. The pre-amp selector switch located in the rear-




the White plug is the Left channel.






cables to the Auxiliary (AUX) or other high-level inputs on your system,

When using the turntable with a computer sound card, set the switch



the computer sound card input.
Assembling the Tone Arm

 
shipment. Temporarily secure the tone arm in the tone arm
 
2. Attach the headshell assembly by inserting it into the
 
good practice always to hold a headshell assembly by the
left and right edges of the headshell to reduce the
possibility of damaging the stylus or disrupting the
cartridge wiring.)
 
headshell locking ring counter-clockwise (to the left).
As the ring turns, it pulls the headshell into its seated
 
removal of the headshell.)
 
to attach the counterweight to the arm extending back
 
counterweight will engage the spiral groove in the rear arm
section and move forward.
Figure 5 – Headshell
Assembling the Turntable Platter and Slip Mat
1. Carefully place the turntable platter on the center spindle,
making certain the platter is fully seated on the spindle.
 
2. Place the soft black slip mat on top of the platter.
Figure 6 – Platter and Slip Mat
Voltage
switch