Specifications

10
Optional System Accessories
MICROPHONES AND CABLES
DR-8HW Headworn hypercardioid dynamic microphone terminated
for use with the UniPak transmitter.
DR-LW Miniature cardioid condenser lavalier/clip-on microphone.
terminated for use with the UniPak transmitter.
DR-GCW Guitar output cable with
1
/
4
" phone plug to locking connector
for use between guitar and UniPak transmitter. 38" long.
Included with DR-3500 system.
RECEIVER ACCESSORIES
AEW-DA660D UHF (655-680 MHz) active unity-gain antenna distribution
system provides two “1-in, 4-out” RF channels; connects a
pair of antennas to as many as four diversity receivers;
cascade output provided as a directional coupler. AC
pass-through allows daisy-chain AC hookup. Defeatable
antenna power. Metal receiver chassis with reinforced
mounting ears and rear rack mount capability. Includes
detachable IEC power cable, IEC pass-through cable, ten RF
cables, front-mount antenna cables and connectors, four DC
power cables to power up to four 2000 Series receivers.
Mounts in a single 19" rack space.
AT8630 Joining-plate kit allows rack-mounting two DR-R30
receivers side-by-side in a single (1U) 19" rack space.
ATW-A20 Pair of UHF ground-plane antennas with
5
/
8
"-27 thread for
mounting to microphone stands, etc. For use with
DR-R30 receivers. Takes RF cables with BNC
connectors, not included; see RF Cables below.
ATW-A49 Pair of UHF wide-band directional LPDA (log periodic dipole
array) antennas provide enhanced signal pickup for UHF
wireless systems throughout a wide band range
(440-900 MHz). Each antenna paddle is matched to 50 ohms
impedance with intergral high-quality low-loss BNC connector;
6 dB gain. For permanent or temporary installation; mounts
to
5
/
8
"-27 threads.
ATW-RA1 Rack-mount antenna kit brings antenna inputs to the front of
receiver for ease of setup, or when receiver is enclosed in a
metal rack. Includes a pair of extendible antennas. NOTE:
Two adapter kits are required when mounting two receivers
side-by-side in a single 19" rack space.
RF Cables Low-loss design, 50 ohm impedance, with BNC-to-BNC
connectors:
AC12 RG58-type cable (12')
AC25 RG8-type cable (25')
AC50 RG8-type cable (50')
AC100 RG8-type cable (100')
TRANSMITTER ACCESSORIES
AT8114 Foam windscreen for handheld transmitter.
AT8141 Water-resistant pouch for UniPak transmitter.
AT8456a Quiet-Flex™ stand clamp for handheld transmitter,
5
/
8
"-27
threads.