Operating instructions

CONTROLS AND INDICATORS

Rear panel

1) Connecting the FM indoor antenna

Connect the enclosed FM indoor antenna. Locate

the wire where the reception will be optimal.

NOTE: It is also possible to connect a central or

outdoor antenna here; either one will provide better

reception than the indoor antenna.

2) Connecting the AM antenna

Connect the enclosed AM antenna. Place the ring

as far from the receiver, TV, and power cables as

possible. Adjust the direction of the antenna for the

best reception.

3) Audio inputs (AUX)

Input for three external audio sources, such as a

CD player, MiniDisc, TV or MP3 player.

4) MAINS [ON/OFF] switch

The mains [ON/OFF] switch must be in the ON po-

sition so the power switch on the front of the panel

can function. The unit should only be turned off

completely if it is not going to be used for longer

period of time, if repair work needs to be done, or

if cables need to be switched out.

5) Subwoofer output

Output for an active subwoofer (with built-in

amplifier). Connect an audio cable between the

subwoofer and this output. A subwoofer is an extra

accessory.

6) Speaker terminals

Connect speaker cables – the right channel to

RIGHT and the left channel to LEFT. Make sure to

also connect + to + and – to – on the speakers. See

separate section page 10.

7) Power outlet

Only connect the power cable after all other con-

nections have been completed.

1 2

3 4

6 7