Operating instructions

ManualsBrandsAudio Pro ManualsComputer equipmentStereo Zero

CONTROLS AND INDICATORS

REMOTE CONTROL

1) Remote function indicator

This LED is lit during any operation made on the re-

mote control.

2) Power switch

Press this button to turn on the receiver, assuming

that it is in standby mode (the indicator LED on the

front panel is red). If it is not red, the receiver is off.

Turn on the receiver with the Main ON/OFF switch on

the rear panel. Press the button again to put the recei-

ver in standby mode.

3) Dimmer

The display intensity can be changed in three steps.

Press to change from High-Low-Off

4) Input (selection of audio source)

Push this button up or down to select the audio sour-

ce – CD/FM/SIDE/USB/AUX1/ AUX2 or AUX3 – chan-

ges. Selected source will be indicated in the display.

5) Bass adjustment

Press to adjust Bass. Change setting using the + or

- knobs (13 or 14).

6) Treble adjustment

Press to adjust Treble. Change setting using the + or

- knobs (13 or 14).

6) Balance adjustment

Press to adjust Balance. Change setting using the +

or - knobs (13 or 14).

8) Select FM/AM

Press to select FM-stereo, FM-mono or AM.

9) Tune -

Press to search next station down the scale.

10) Numerical buttons

The numerical buttons 0-9 permit the user to select:

CD mode: track number.

Tuner mode: pre-set radio stations

11) Muting

Mute the audio with this button. Press it again to

return to the previous volume level. Muting will be

indicated on the display.

12) Volume (volume control)

Push up to increase volume or push down to de-

crease the volume.

13) + button

Press to increase setting of Bass, Treble or Balance

14) -button

Press to decrease setting of Bass, Treble or Balance

15) Speaker selector

Press to change speaker setting from Large to Small.

The setting is show in the display.

16) CD/USB player controls:

Press to start playback

Press to pause playback

Press to stop playback

Press to skip to next track

Press to skip to previous track

17) RDS selector

Press to change RDS display RDS PS, RDS RT or

RDS OFF

18) Tune +

Press to search next station up the scale.

19) Repeat

Press to select repeat function. One - All - Off

20) Memory (accessing the memory)

Press this button to access the memory. See separate

section page 13.

The battery cover is located on the back of the remote

control.