Operating instructions

17
TROUBLESHOOTING
If a unit does not function or perform as expected, the problem is not always a mechanical one. The
solution may be found in the table below. Check here before you contact your retailer or authorized service
center
Symptom: Possible cause: Possible correction:
Absence of sound * Speaker cables not connected * Connect according to the diagram on page 10
* Volume set at minimum * Turn up the volume
* Muting activated *Turn up the volume or press the muting button
on the remote control
* Headphones are connected * Turn the volume to minimum and disconnect
the headphones
No sound from the left or right speaker * The speaker cables are not connected * Connect the cables according to the diagram
on page 10
Poor or absent FM reception * The FM antenna is not connected *Connect the FM antenna. See page 11
* No stations are set * Find correct frequency. See page 13
* AM chosen as frequency * Select FM Stereo. See page 13
No FM stereo reception * FM Mono or AM chosen as frequency * Select FM Stereo as frequency. See page 13
A pre-set station can not be accessed * No broadcasting * Wait for a broadcast from the station
* Station erased from memory * Search for the station and pre-set it again
Poor or absent AM reception * The AM antenna is not connected *Connect the AM antenna. See page 11
A CD does not play * The CD is upside down * Put the CD in the tray with the label face up
* The CD is very dirty * Carefully clean the CD
* The CD is very scratched * Tr y a different CD
* Condensation on the optical lens * If the unit has been subjected to extreme tem-
perature fluctuations, do not use it for a while
* Another audio source selected * Select CD as SOURCE button or press PLAY
Remote control functions poorly or not at all * The batteries are burned out * Install new AAA batteries
* The battery polarities are incorrect * Insert the batteries according to the diagram
in the battery compartment
* Out-of-range usage * Use the remote control within its range. See
page 11
* Remote control not aimed at the front panel * Aim the remote control toward the front panel.